We have you covered when it comes to fluke accessory and replacement parts for your test and measurement equipment. Find parts that enhance your equipment or replace an existing one.
Insert D for the 9103 Dry Block Temperature Calibrator has three pairs of metric sized wells.
Blank Insert for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Block Insert replacement for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Block Inserts for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Comparison block insert for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
If you have a non-standard application that requires custom diameter holes in your insert start with these blank inserts and create your own. This insert is designed for use with the 9141 Field...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Multi-hole Insert, 1/16", 1/8", 3/16", 1/4", 3/8", 1/2".
Multi-hole Insert, 2 ea. at 3/16", 1/4", 3/8".
Multi-hole Insert, 6 at 1/4".
Insert A for 9103 Dry Block Temperature Calibrator. Insert A handles a full range of probe sizes with a single well of each size (1/16", 1/8", 3/16", 1/4", 3/8", 1/2").
Insert B features two wells each of 3/8", 1/4", and 3/16" in diameter for doing comparison calibrations.
Insert C has 4 x 1/4" (6.35 mm) diameter wells for multiple probe calibrations.
Insert D has three pairs of metric sized wells.
Blank Insert for use with Fluke Dry Block Calibrators.
This furnace uses Hart's microprocessor-based controller for great stability and setpoint accuracy. It features a rapid cool-down and heat-up time and an RS-232 port for connection to a PC.
This fuse pack is intended for use as an accessory for the SMFT-1000 PV tester.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
