We have you covered when it comes to fluke accessory and replacement parts for your test and measurement equipment. Find parts that enhance your equipment or replace an existing one.
Sun Visor for the Fluke Ti200, Ti300 and Ti400 Thermal Imaging Cameras.
Replacement Pump Kit for the Fluke 718 Pressure Calibrators.
250V Voltage rating, 630mA Current rating. Pack of 5.
Fast acting replacement fuse for Fluke Digital Multimeters. Comes in packs of 5. The fuse current is 440mA and voltage rating VAC is 1kV.
(P/N 203411) Fuse 440MS, 1000V Fast. QTY 1 per Blister Pack.
(P/N 871202) Fust 3A, 600V. QTY 5 per Blister Pack.
(P/N 871207) Fuse 1A, 600V Fast. QTY 5 per Blister Pack.
Replacement fuse for digital multimeters.
Replacement fuse for digital multimeters.
This fuse pack is intended for use as an accessory for the SMFT-1000 PV tester.
This furnace uses Hart's microprocessor-based controller for great stability and setpoint accuracy. It features a rapid cool-down and heat-up time and an RS-232 port for connection to a PC.
Blank Insert for use with Fluke Dry Block Calibrators.
Insert D has three pairs of metric sized wells.
Insert C has 4 x 1/4" (6.35 mm) diameter wells for multiple probe calibrations.
Insert B features two wells each of 3/8", 1/4", and 3/16" in diameter for doing comparison calibrations.
Insert A for 9103 Dry Block Temperature Calibrator. Insert A handles a full range of probe sizes with a single well of each size (1/16", 1/8", 3/16", 1/4", 3/8", 1/2").
Multi-hole Insert, 6 at 1/4".
Multi-hole Insert, 2 ea. at 3/16", 1/4", 3/8".
Multi-hole Insert, 1/16", 1/8", 3/16", 1/4", 3/8", 1/2".
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
