Extend the capability of your meters with test leads and probes from Fluke. These accessories are compatible with a wide range of Fluke products including multimeters, clamp meters and more.
One pair (red, black) of leads with very small tips to access hard to reach electronic test points.
Provides five different ways to connect to terminals, this test lead set features 60" (1.5 m), silicone-insulated leads, useable from -112 to 158°F (-80 to 70°C), and is rated for 30...
Features flexible silicone insulated leads are heat and cold resistant and are Cat I 30 V, 10 A rated.
Provides an easy connection past weather pack seals to connector conductors.
The set comes equipped with a pair (red, black) of flexible silicone insulated test leads with sharp needlepoint tips that are adjustable to the desired length from 0 to 3" (0 to 76 mm). The...
Designed to improve steadiness with rubber overmolded surfaces and finger-hugging curves. For use with TL222 and TL224 test leads.
Test lead set for connecting measurement input to Fluke 17XX Power or Energy Loggers. The connectors are non stackable.
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
Comes equipped with one pair (red, black) of flat, right angle design for connecting to bus bars, and CAT III 600 V, 5 A rating, CSA listed. Adjustable collar provides two ranges of jaw openings...
Single probe pierces 0.01 to 0.6" (0.25 to 1.5 mm) insulated wire with a small pin allows self-healing of the insulation, and 1000 V, 10 A maximum.
Set of three (red, gray, black) safety designed insulated alligator clips for use with STL 120 Shielded Test Leads and TL75 Test Leads. Features a nickel-plated steel jaw contact material with a...
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
DMM test leads (red, black) with safety shrouded, standard diameter banana plugs.