We offer a variety of test leads and probes for your Fluke 179 to ensure you are ready for every application.
Single probe pierces 0.01 to 0.6" (0.25 to 1.5 mm) insulated wire with a small pin allows self-healing of the insulation, and 1000 V, 10 A maximum.
Comes equipped with precision electronic probes with multiple spring loads sharp tips that are designed to maximize contact with SMD test points. Additionally, this master test lead set also comes with modular test leads and lead-probe combinations ideal for long lead applications.
Designed to extend the voltage measuring capability of an AC/DC voltmeter to 6000 V peak AC or DC Overvoltage Category I. The probe provides high accuracy when used with a voltmeter having 10 MΩ input impedance. Intended for low energy applications.
Comes with hard stainless steel probe tips, this slim reach test probes set comes in one pair of slender probe bodies that for probing closely spaced or recessed terminals. Additionally, they feature an insulated probe tip.
DMM test leads (red, black) with safety shrouded, standard diameter banana plugs.
Set of three (red, gray, black) safety designed insulated alligator clips for use with STL 120 Shielded Test Leads and TL75 Test Leads. Features a nickel-plated steel jaw contact material with a standard jaw opening of 5/16" (8 mm), and accepts standard 0.08" (2 mm) pin tip sized test probes.
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can focus on making an accurate measurement.
Comes equipped with one pair (red, black) of flat, right angle design for connecting to bus bars, and CAT III 600 V, 5 A rating, CSA listed. Adjustable collar provides two ranges of jaw openings up to 1.81" (30 mm).
Comes in a small and rugged design, this probe light kit liberates the users' hands for work. Additionally, it features a bright white LED and fits between the modular test probe and test lead.
Features flexible silicone insulated leads are heat and cold resistant and are Cat I 30 V, 10 A rated.
Provides five different ways to connect to terminals, this test lead set features 60" (1.5 m), silicone-insulated leads, useable from -112 to 158°F (-80 to 70°C), and is rated for 30 V, 8 A.
Compatible with a variety of Fluke multimeters and test leads, this fused test probe set provides firm and secure contact.
Ideal for high-energy environments. Additionally, this kit comes equipped with a probe extender and probe light, which allows users to illuminate those hard-to-reach areas.
Ideal for electrical and electronic testing in industrial environments. Additionally, the master test lead set is compatible with a variety of meters and extends the meter's capabilities.
Designed to extend the voltage measuring capability of an AC/DC voltmeter to 40,000 V peak AC or DC Overvoltage Category I. The probe provides high accuracy when used with a voltmeter having 10 MΩ input impedance. Intended for low energy applications.
Designed to extend the voltage measuring capability of an AC/DC voltmeter to 15,000 V peak AC or DC Overvoltage Category I. The probe provides high accuracy when used with a voltmeter having 10 MΩ input impedance. Intended for low energy applications.
A high-frequency probe designed to convert a DC voltmeter with an input impedance of 10 MΩ into a high frequency (100 kHz to 500 Mhz) RF voltmeter. Additionally, it's probe's DC output is calibrated to equal the RMS value of sine wave input.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
