All of the test leads and probes for your Fluke 87-V Multimeter.
Test Leads designed to improve steadiness with rubber overmolded surfaces and finger-hugging curves.
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can focus on making an accurate measurement.
Features a tapered tip, making this tapered temperature probe ideal for use in air, non-caustic gas, and surface applications.
A K type thermocouple probe ideal for use in air and non-caustic gas measurements. Additionally, this air temperature probe features a bead protected by perforated baffle.
Included with kit: Fluke i410 (1-400A AC RMS, 1-400A DC Current Clamp) and a Zippered vinyl carry case with moveable divider.
Kit includes TL940 Mini-Hook Test Lead Set, TL950 Mini-Pincer Test Lead Set, and TL960 Micro-Hook Test Lead Set.
The set comes equipped with a pair (red, black) of flexible silicone insulated test leads with sharp needlepoint tips that are adjustable to the desired length from 0 to 3" (0 to 76 mm). The extra strength probe tips to provide a long service life and the test leads have a CAT III 300 V, 3 A rating, UL listed.
Pair of red, black silicone test leads with right angle shrouded 0.16" (4 mm) banana plugs.
Provides five different ways to connect to terminals, this test lead set features 60" (1.5 m), silicone-insulated leads, useable from -112 to 158°F (-80 to 70°C), and is rated for 30 V, 8 A.
Single probe pierces 0.01 to 0.6" (0.25 to 1.5 mm) insulated wire with a small pin allows self-healing of the insulation, and 1000 V, 10 A maximum.
Comes equipped with one pair (red, black) of flat, right angle design for connecting to bus bars, and CAT III 600 V, 5 A rating, CSA listed. Adjustable collar provides two ranges of jaw openings up to 1.81" (30 mm).
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can focus on making an accurate measurement.
Designed to extend the voltage measuring capability of an AC/DC voltmeter to 15,000 V peak AC or DC Overvoltage Category I. The probe provides high accuracy when used with a voltmeter having 10 MΩ input impedance. Intended for low energy applications.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
