Find a wide selection of Fluke adapters to help connect your DMMs, eliminate stray voltage or connect your equipment to your PC.
For use with Norma series Power Analyzers.
Ideal for situations when the sensor tip of the 805 Vibration Meter is difficult to access.
Lines & Fittings Kit for 2271A-NPT-HC20
Specifically designed as an economical system for getting PV modules on rooftops quickly and safely without damaging them, this lift is compatible with fiberglass extension ladders from Werner and...
Specifically designed as an economical system for getting PV modules on rooftops quickly and safely without damaging them, this lift is compatible with fiberglass extension ladders from Werner and...
This incremental weight set is designed for use with select psi weight sets.
For use with 1760 Energy Logger & TOPAS 2000 Analyzer.
Thin, flexible probes for use with the 1760 series Energy Logger and Recorders.
This fine increment weight set is designed for use with select kPa, mPa, bar and kgf/cm2 weight sets.
Adaptor Set for Standard Test Port, 20MPA
Hydraulic test hose 10,000 psi, 700 bar working pressure test hose that features stainless steel and nylon construction.
Tank Extension Adapter for the 6102, 7102 and 7103 Liquid Bath Calibrators.
Adaptor Set for P3000 Test Port, 20MPA
Seven-piece set for performing 3- and 4-pole fall-of-potential testing that measures the ability of the earth ground system or individual electrode to dissipate energy from the site.
For use with Norma series Power Analyzers.
For use with MDA-500 Motor Drive Analyzer models.
Remove and refit a pressure gauge's pointer both consistently and quickly using this deadweight tester's pointer remover/punch.
Expand your deadweight tester's capability with this angle adapter, which uses the standard gauge adapters and positions the gauges at 90º.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
