Find a wide selection of Fluke adapters to help connect your DMMs, eliminate stray voltage or connect your equipment to your PC.
Specifically designed as an economical system for getting PV modules on rooftops quickly and safely without damaging them, this lift is compatible with fiberglass extension ladders from Werner and...
Specifically designed as an economical system for getting PV modules on rooftops quickly and safely without damaging them, this lift is compatible with fiberglass extension ladders from Werner and...
Compatible with current clamps featuring an output maximum of 1 V AC/DC, this BNC adapter allows the connection of AC or DC clamps to 17XX multimeters. In addition, this adapter consists of a...
Compatible with current clamps featuring an output maximum of 2.8 V AC/DC, this BNC adapter allows the connection of AC or DC clamps to 17XX multimeters. In addition, this adapter consists of a...
For data transmission/access via the cell phone network, this LTE module allows communication with 177X multimeters (the multimeter must be close enough to a compatible cell tower). In addition,...
Designed for the 9140 field dry well, it has additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts.
Expand your deadweight tester's capability with this metric adapter set, which includes M14 x 1.5, M20 x 1.5, 1/8 and 1/4 BSP adapters.
Expand your deadweight tester's capability with this BSP adapter set, which includes 1/8, 1/4, 3/8 and 1/2 BSP adapters.
Expand your deadweight tester's capability with this NPT adapter set, which includes 1/8, 1/4, 3/8 and 1/2 NPT adapters.
Keep your 1620A digital thermometer-hygrometer charged with this 100 to 240V power supply.
Properly seal your existing P3100 Series deadweight tester with help from this seal kit.
This relay card is designed for use with the DAQ-STAQ multiplexer.
This 15V AC adapter can be used to keep your 1529 Chub-E4 standard thermometer fully powered.
Expand your deadweight tester's capability with this angle adapter, which uses the standard gauge adapters and positions the gauges at 90º.
For 1594A and 1595A models, you can use this adapter, which converts female LEMO connections to female spade lug connections.
Compatible with 1521 and 1522 INFO-CON models, this accessory adapts LEMO to INFO-CON connections.
Remove and refit a pressure gauge's pointer both consistently and quickly using this deadweight tester's pointer remover/punch.
This fine increment weight set is designed for use with select kPa, mPa, bar and kgf/cm2 weight sets.
This incremental weight set is designed for use with select psi weight sets.
Standard accessory for Fluke 165XB Electrical Installation Tester.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
